Arduino Communications Using the netcat(nc) Utility

From Combustory
Revision as of 00:57, 8 September 2012 by Jvaughters (Talk | contribs)
Jump to: navigation, search

Overview

Why reinvent the wheel. I have seen very complicated methods for communicating with the Arduino, Including some I have made on my own. What I have recently found out is that the easiest way to communicate to the Arduino is using the existing tool netcat. It is soooooo simple and super powerful. You can send the output to a Network port and access the communications from literally any place in the world.

Assumptions

  • You have basic knowledge of command line usage
  • You know how to load a program to the Arduino

Mini2440 or Embedded Systems

Embedded systems like the Mini2440, use Busy Box as a small utility package that includes a version of nc that makes communications to Arduino a breeze. All you have to do is go to a terminal and use these two commands after you plug in the Arduino.

stty -F /dev/ttyUSB0 cs8 115200 ignbrk -brkint -icrnl -imaxbel -opost -onlcr -isig -icanon -iexten -echo -echoe -echok -echoctl -echoke noflsh -ixon -crtscts
nc -f /dev/ttyUSB0

You should now have a terminal session that is communicating with the Arduino. Of course you should have a program that responds to serial communication on the Arduino, or nothing will be happening. How this works is the nc command has redirected the input and output streams of the /dev/ttyUSB0, which is the Arduino terminal and the stty command sets the serial communication parameters.

Personal tools
Sponsers
Your Ad Here
Your Ad Here